Measuring leakage current in RF power transistors

October 26, 2011 // By William R. Murphy, Richardson RFPD
Around the globe, engineers and technicians using RF power devices have had many concerns regarding the specifications for leakage current, what the specifications mean in terms of the part's performance in the field, and most importantly, how to properly test/verify that a given part is meeting its printed leakage current specification...

What, specifically, is “transistor leakage current”?

A transistor can be thought of as a simple “ON/OFF” semiconductor device. In an ideal sense then, the transistor only allows DC current to flow through it when it is “ON” (i.e. properly biased and with the proper DC supply voltages applied), and allows zero DC current flowing through it, when it is “OFF.” In reality, a small amount of DC current still flows through all transistors, even when they are in their “OFF” state, as long as the DC supply voltages are applied. This relatively low-level of DC “OFF” current is commonly referred to as transistor leakage current. Leakage current is present in every type of transistor, using any semiconductor technology (Bipolar, CMOS, VMOS, LDMOS, GaAs, GaN, etc.).

Note: Leakage current for bipolar junction transistors (BJT) is commonly referred to as ICEO, the collector-emitter cutoff current (base open). This is one reason why you seldom find the words “leakage current’ in older transistor data sheets and data books. With the advent of Field-Effect Transistors (FETs), and the subsequent FET technology advancements (VMOS, LDMOS, etc.), BJTs have decreased dramatically in usage as RF power transistors.

“Normal” leakage current, or the expected amount of leakage current that is within a given part’s specifications, is due mainly to imperfections and limitations in the transistor die. The actual causes of this expected leakage current are beyond the scope of this paper.

Leakage current specifications for transistors

Leakage current is specified today in virtually every transistor data sheet. For the most part, though, the leakage current specifications are rarely noticed, and are almost never a cause for concern by RF power design engineers. This is because leakage current is typically very low, usually in either the low µA range or even the nA range. Since leakage current is so low, it is only considered “design-impacting” when:

  • The transistor is used in extremely low power applications; or,
  • In rare
Design category: 

Vous êtes certain ?

Si vous désactivez les cookies, vous ne pouvez plus naviguer sur le site.

Vous allez être rediriger vers Google.