The 0302 size EW Series is, its makers say, a new breed of gain equaliser. They are a low cost solution that provides slope correction from DC to 18 GHz of greater than 3 dB. They are designed for superior, repeatable microwave performance to compensate for gain roll-off and VSWR mismatch losses and are a good match to a 50ῼ line width for optimal broadband performance. Six slopes are available and are footprint interchangeable for optimising module gain flatness from 1 to 3.5dB.
Solderable terminations are compatible with solder SMT and conductive epoxy assembly and pick and place equipment. No ground connection is required. They are available in tape and reel packaging for high volume applications. Engineering kits are offered which contain all 6 slope part types.
Applications include broadband microwave modules; EW, ECM, ECCM and as an equaliser used as a compensation circuit to correct for loss slope created by other circuit elements, such as amplifiers.
DLI gain equalisers employ monolithic construction with a precision thin film conductor and resistor films together with proprietary high dielectric constant ceramics for superior RF performance repeatability. Integrated R and C values are realised to produce the desired gain slope. DLI's miniature thin film gain equalisers have a microwave frequency response which is so close to ideal that it can be modelled by the simple parallel R-C circuit.
A gain equaliser is intended to be used in small signal applications, the limitation is principally thermal dissipation being a combination of very small part size and low thermal conductivity of printed wire board materials. The dissipated power will be greater for signals in the lower frequencies in contrast to the higher frequency end of the design range where the insertion loss reaches a typical value of 0.2 dB. Typical dissipated power limit is 30 mW or greater for baseplate temperatures up to 80° C.
Knowles Capacitors (Incorporating Dielectric Laboratories (DLI), Novacap, Syfer Technology and